Akash Kumar1, Anindya Debnath1, Antar Banik1, Kabirul Islam Mondal1, Partha Pratim Biswas1, Rik Bhattacharyya1, T K Maiti2
（1. Department of Applied Electronics & Instrumentation Engineering, Netaji Subhash Engineering College, Kolkata 700152, West Bengal；2. Department of Instrumentation Engineering, Central Institute of Technology Kokrajhar, Assam 783370, India）
Abstract： The design and development of a timer based revolution per minute (RPM) measurement system were described in this paper. The rotating shaft of a dc motor was used to measure the RPM and timer integrated circuit(IC) 555 was used in astable mode. The frequency of timer output waveform measured by a digital storage oscilloscope (DSO) is almost linearly proportional to the RPM of rotating shaft, and the RPM also linearly varies with the change of the external input voltage level. Hence the linear relationship between the frequency of timer output waveform and the RPM can be obtained. The main advantages of this developed system are linear input-output relationship, small size, easy to carry and cost effective.
Key words： IC 555； astable multivibrator； RPM measurement
CLD number： TP216 doi： 10.3969/j.issn.1674-8042.2020.02.012
References
［1］Bell D A. Electronic devices and circuits. 4th Edition. Englewood: Prentice-Hall, 2003: 735-736.
［2］OPTO 22. RPM Measurement Techniques. Technical Note， 1784: 160609.
［3］Wang L J, Yan Y, Hu Y H, et al. Rotational speed measurement using single and dual electrostatic sensors. IEEE Sensors Journal, 2015, 15(3): 1784-1793.
［4］Didosyan Y S, Hauser H, Wolfmayr H, et al. Magneto-optical rotational speed sensor. Sensors and Actuators A (Physical), 2003, 106(1-3): 168-171.
［5］Lin H, Ding K. A new method for measuring engine rotational speed based on the vibration and discrete spectrum correction technique. Measurement, 2013, 46(7): 2056-2064.
［6］Wang L, Yan Y, Hu Y, et al. Rotational speed measurement through electrostatic sensing and correlation signal processing. IEEE Transactions on Instrumentation and Measurement, 2014, 63(5): 1190-1199.
［7］Compact instruments. http://www.compactinstruments.co.uk/shop/advent-range/advent-general-purpose-opticalcontact-tachometers/Accessed17 August 2014.
［8］Coughlin R F, Frederick F. Operational amplifiers and linear integrated circuits. New Jersey: Prentice Hall, 2001.
［9］Texas Instruments. LM 555 Timer datasheet. ［2015-01-03］. http://www.ti.com/lit/ds/symlink/lm555.pdf.
［10］Electrical 4U. Permanent magnet DC motor or PMDC motor1 working prineiple & construction. ［2019-07-11］. http://www.electrical4u.com/permanent-magnet-dc-motor-or-pmdc-motor.
［11］Vishay Semiconductors GmbH. Photo modules for PCM remote control systems. https://www.batronix.com/pdf/tsop17xx.pdf.
简易转速测量系统设计
Akash Kumar1, Anindya Debnath1, Antar Banik1, Kabirul Islam Mondal1, Partha Pratim Biswas1, Rik Bhattacharyya1, T K Maiti2
（1. Netaji Subhash工程学院 应用电子与仪器工程系， 加尔各答 700152， 西孟加拉；2. 科克拉贾尔中央理工学院 仪器工程系， 阿萨姆 783370， 印度）
摘 要： 介绍了一种基于定时器的转速测量系统的设计与开发。 使用直流电动机的转轴来测量其转速， 定时器IC 555用于不稳定模式。 使用数字存储示波器(DSO)测量的定时器输出波形的频率几乎与转轴的转速成线性比例， 而这个转速又与外部输入电压水平的变化成线性关系， 由此得到了定时器输出波形频率与转速之间的线性关系。 该系统的主要优点是线性输入-输出， 体积小， 便于携带且成本低。
关键词: 定时器IC 555； 非稳多谐振荡器； 转速测量
引用格式： Akash Kumar, Anindya Debnath, Antar Banik, et al. Development of a simple RPM measurement system. Journal of Measurement Science and Instrumentation, 2020, 11（2）： 193-196. ［doi： 10.3969／j.issn.1674-8042.2020.02.012］
[full text view]
